Browse SAE J ORFS O-Ring Face Fittings in the World Wide Metric, Inc. catalog including Nuts and Rings,Equal Fittings,Male Stud Coupling,Bulkhead. The Seal-Lok fitting meets or exceeds the strict requirements of SAE J and ISO It is an O-ring face seal type fitting that consists of a nut, a body. Thread Specification – ORFS (SAE J). TECHNICAL DATA. SAE J, ISO ORFS is O RING FACE SEAL. ORFS system consists of ORFS.
|Published (Last):||10 March 2010|
|PDF File Size:||2.27 Mb|
|ePub File Size:||8.52 Mb|
|Price:||Free* [*Free Regsitration Required]|
Purpose The three parts of SAE J cover material, dimensional, and performance requirements of steel O-ring face seal ORFS connectors for tubing and the O-ring face seal sae j1453 and nut portion of hose stem assemblies for nominal tube diameters of sae j1453 mm through 50 mm.
This standard is available for individual purchase. IHS Standards Expert subscription, simplifies and expedites the process for finding and managing standards by giving you access to standards from over standards m1453 organizations SDOs. These connectors are intended for general application see Figures 3, 4, and 5 and hydraulic systems on industrial equipment and commercial products, sae j1453 elastomeric seals are acceptable to overcome leakage and variations in assembly sae j1453.
sae j1453 Click here to skip or ad will close in 15 seconds. Price and Buy this Standard View Pricing.
ORFS MALE O-RING SEAL ISO SAE J hydraulic test fittings – Ruihua Hardware
Mitigate liability and better understand compliance sae j1453 Boost efficiency: Field of Application Sae j1453 connectors are intended for general application see Sae j1453 3, 4, and 5 and hydraulic systems on industrial equipment and commercial products, where elastomeric seals are acceptable to overcome leakage and variations in assembly procedures. In the past, these connectors have been used predominantly with inch tubing. Inch hex dimensions of parts will be moved from the main document to an informative annex after For any application, it is recommended that sufficient testing be conducted and reviewed by both sze user and manufacturer to ensure that required performance levels are met.
Both metric and inch tubing saee be accommodated by changing only the sleeve to match the tube diameters. For use of these connectors in conditions outside the pressure sae j1453 temperature limits specified, the manufacturers must be consulted.
Since many factors influence the pressure at which a hydraulic system will or will sae j1453 perform satisfactorily, these values should sae j1453 be construed as guaranteed minimums.
Speed up research, capture and reuse expertise For additional product information, visit the IHS Standards Expert page.
Identify unmet needs and discover next-generation technologies Improve quality by leveraging consistent standards to meet customer and market requirements Minimize risk: This Standard References Showing 10 of sae j1453 The rated working pressure of sae j1453 fluid conductor assembly using Sae j1453 J hose stem connections or formed tube or braze-on tube connections shall not exceed rated working pressure of the lowest rated component sae j1453.
The three parts of SAE J cover material, dimensional, and performance requirements of steel O-ring face seal ORFS connectors for tubing and the O-ring face seal interface and nut portion of hose stem assemblies for nominal tube diameters of 6 mm through 50 mm.
For new designs metric tubing should be considered.